The FunduMoto L298P Motor Driver Shield is a multi-featured motor shield based around the L298P driver chip and fits Arduino Uno or other Arduino with compatible I/O pins.

Arduino product family is a great learning platform for electronics, programming and robotics. But most projects at some point require mobility. This board allows for motor control with Arduino right away. Stack up this shield on your controller and drive motors with  higher power requirements. Depending on the motor of choice, you can make it fast or handle a higher payload. This Arduino Compatible Motor Shield (2A) uses L298P chip which allow to drive two 7-12V DC motors with maximum 2A current. This shield can be directly mounted onto standard Arduino Duemilanove and Arduino Mega.

KEY FEATURES OF L298P MOTOR DRIVER SHIELD:

• Drive 2 DC motors at 4.8-24V at up to 2A peak (2.5A peak) current.
• Built-in Schottky diodes to protect against motor back EMF.
• Drive 1 servo motor with a dedicated 5V regulated power.
• Built-in buzzer.
• Remote reset switch.
• Bluetooth connector (x2).
• Ultrasonic Range Finder Ping connector.
• RGB LED connector
• 6 Analog/digital pins brought out to 3-pin headers with 5V and Gnd available for each input for easy sensor hookup.
• Stacking female connectors for supporting another daughter card.
• Can optionally power attached Arduino off the shield.

Specifications: